Velleman К8077 Manuel d'utilisateur télécharger pdf (Page 24)

(I) - Fix the speaker wires with some glue and trim them to a length of 20cm

- Slide an insulating sleeve over both wires. Solder a connector to both

wires and slide the insulating sleeves over the connector.

- Fix the 4 plastic feet by means of a 23mm screw and put the enclosure

on its feet.

(J) - put the heatsink in place and mark the 10 holes.

- remove the heatsink

- pre-drill the holes with a 1.5mm drill

- connect the red speaker wire to the connector marked 'LS+'

- connect the black speaker wire to the connector marked 'LS-'

- Carefully put the amplifier module in place.

- Fix the heatsink using ten 10mm black screws

Enclosure assembly

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Velleman К8077 Manuel d'utilisateur Page 24