Velleman VDPLW1601 Manuel d'utilisateur télécharger pdf (Page 5)

VDPLW1601

07.09.2010 ©Velleman nv

6. Operation

Refer to the illustrations on page 2 of this manual.

• The VDPLW1601 can work stand-alone with fixed colour output or controlled by an external DMX-

controller (not incl.).

• The VDPLW1601 in master mode generates DMX values on the DMX output [6]

. Linked devices will

follow the behaviour of the master when they are placed in slave mode.

• All settings are made through the DIP switch [5]. Note: “-” = OFF

mode \ DIP switch 1 2 3 4 5 6 7 8 9 10

Slave (DMX-512) DMX address ON

Master, automatic select effect - -

Master, sound controlled select effect ON -

a) DMX-512 (slave mode)

• All DMX-controlled devices need a digital start address so that the correct device responds to the

signals. This digital start address is the channel number from which the device starts to “listen” to

the DMX controller. The same starting address can be used for a whole group of devices or an

individual address can be set for every device.

• When all devices have the same address, all the units will “listen” to the control signal on one

particular channel. In other words: changing the settings of one channel will affect all devices

simultaneously. If you set individual addresses, each device will “listen” to a separate channel

number. Changing the settings of one channel will only affect the device in question.

• In case of the 6-channel VDPLW1601, you will have to set the start address of the first unit to 1

(CH1~6), the second unit to 7 (1 + 6) (CH7~12), the third to 13 (7 + 6) (CH13~18), and so on.

• The start address is set using DIP-switch 1 through 9 (binary add).

address 1 2 3 4 5 6 7 8 9 10

1 ON - - - - - - - - ON

7 ON ON ON - - - - - - ON

13 ON - ON ON - - - - - ON

19 ON ON - - ON - - - - ON

25 ON - - ON ON - - - - ON

31 ON ON ON ON ON - - - - ON

… … … … … … … … … … ON

• Refer to the table below for an overview of the control signals per channel.

Channel DMX-512 value Control Programs

CH1

RGBW luminance adjust 0～136 Adjust the total luminance of light

RGBW colour change 137～187 CH6=0, adjust colour change speed

RGBW gradual colour change

188～239 CH6=0, adjust gradual colour change speed

Run programmed effect

240～249

250～255

Automatic-running effect

Automatic-sound effect

CH2 Red 0～255 Adjust red LED luminance

CH3 Green

0～255

Adjust green LED luminance

CH4 Blue 0～255 Adjust blue LED luminance

CH5 white 0～255 Adjust white LED luminance

CH6

Flash 0～255 Adjust flash frequency

CH1 Set flash frequency

137～239

Adjust RGBW flash colour change frequency

1 2 3 4 5 6 7 8 9 10 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Velleman VDPLW1601 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Velleman VDPLW1601