Velleman DVBTR Manuel d'utilisateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 53
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
DVBTR_v2 VELLEMAN
- 12 -
9. Troubleshooting
Some simple checks or a minor adjustment may eliminate the problem and restore proper operation. Let a technician
maintain the unit.
Keep the device away from static electricity during maintenance as the video processor is very sensitive.
Trouble Possible Cause Suggested Solution
No power
Power cord has not been connected
properly
Plug the power cord tightly into the power
outlet and switch on the power. If there still
is no power, switch off the unit again and
wait 5 to 10 min. before switching the unit
on
Can not scan program
Antenna is not adjusted properly
Parameter input is incorrect
Use the antenna correctly
Adjust the antenna or use an outdoor
antenna
Use an antenna with a 75 impedance
Set the frequency and bandwidth
correctly
No picture
Output cord incorrectly connected
Video output mode of the unit is set
differently than the mode of the
monitor
Connect the output cord correctly
Reset the working mode
No colour
Output cord incorrectly connected
Video output mode of the unit is set
differently than the mode of the
monitor
Connect the output cord correctly
Reset the working system
Image distortion from one
channel to another
Normal
The RCU is not working
Batteries incorrectly inserted
Batteries are exhausted
Operation distance is too far or
operating angle is too large
Remote control sensor is obstructed by
bright light
Insert the batteries correctly
Replace the batteries
Operate within the range
Place the unit in another place
Audio sound and subtitle
cannot be chosen
Sound channel incorrectly chosen
Press the AUDIO button to shift the
channel
No sound
Mute button is pressed
Volume is set at a low level
Cable incorrectly connected
Cancel the mute
Augment the volume
Connect the cable correctly
Sudden sound drop
Short circuit
Mute button is pressed
Entering sleeping status
Connect the output cable correctly and
reopen the unit
Cancel the mute
Reopen the unit
Seriously distorted
reception
Serious interferential status Adjust the antenna
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 52 53

Commentaires sur ces manuels

Pas de commentaire