Velleman DVM8855 Manuel d'utilisateur télécharger pdf (Page 6)

DVM8855

7. Software installation and use

Driver installation

• Plug the USB connector of the receiver into a free powered USB port of a PC. The system should

recognize the new hardware automatically: CP2102 USB to UART Bridge Controller.

• The ‘Found New Hardware Wizard’ pops up:

• Select ‘I

nstall the software automatically (Recommended)’ option and click ‘Next >’.

• The ‘Completing the Found New Hardware Wizard’ window pops up. Click on ‘Finish’.

• Verify the driver installation in the Device manager. Go to ‘My computer’ – ‘System information’ –

tab ‘Hardware’ and click on ‘Device Manager’. Look for ‘CP2102 USB to UART Bridge Controller’

under section ‘Ports (COM & LPT)’. A COM-port was assigned to this bridge controller; it is

mentioned between brackets at the end of the line. Remember this number as it is needed to

configure the software. Double click (left) on the device name to see more details.

1 2 3 4 5 6 7 8 9 10 11 ... 48 49

Pas de commentaire

Velleman DVM8855 Manuel d'utilisateur Page 6