Velleman VMB4PD Manuel d'utilisateur télécharger pdf (Page 33)

VMB4PD

Troubleshooting

No display:

• The display contrast is too low. Hold the configuration button pressed for 3 seconds to switch the

module to the configuration menu which allows modifying contrast. Hold the upper right push button

pressed for 8 seconds. The contrast will be set at its maximum.

• Selection of blank characters during labelling. Press the configuration button a couple of times until a

blinking cursor is displayed in the upper left corner. Enter your label using the 4 push buttons.

• Remove the power supply during min. 10 seconds.

The remote control stick does not function:

• Drained batteries in the transmitter. Replace the batteries.

• Addresses of the transmitter/receiver are not synchronized. See “Addressing” and the transmitter’s

notice.

1 2 ... 28 29 30 31 32 33 34 35

Pas de commentaire

Velleman VMB4PD Manuel d'utilisateur Page 33