Velleman CAMCOLVC18 Manuel d'utilisateur télécharger pdf (Page 11)

CAMCOLVC18

V. 04 – 06/09/2013 11 ©Velleman nv

Note: to disconnect the camera from the pc, use Windows’ Safely Remove

Hardware function to stop the device before you unplug the USB cable.

7.7 Deleting video files

Caution: Back up the video files to your pc first, if necessary.

1. Make sure that recording is stopped.

2. Press and hold the menu button for 2 seconds.

3. Press the record button repeatedly.

The display shows ”D” (for “delete”). On the display blinks, in sequence:

o “NO”: press the record button to go to the next option.

o “ONE”: press the menu button to delete the last recorded video file.

“ONE” stops blinking while the camera deletes the file. Wait until

“ONE” starts blinking again: then you can delete the next recorded

video file. Or, press the record button to exit.

o “ALL”: press the menu button to delete all recorded video files.

“ALL” stops blinking while the camera deletes the files. Wait until

“ALL” starts blinking again, then press the record button to exit.

7.8 Using as a webcam

You can use the camera as a webcam if you install the included software.

1. Make sure the camera is not connected to your pc.

2. Insert the included CD in your computer's CD drive.

3. Locate and double-click the STK03N icon on the CD-ROM.

4. Follow the instructions of the installation wizard.

5. When the software is installed, make sure the camera is switched off.

6. Unscrew the cap [1] from the back of the camera.

7. Insert one end of the USB cable (included) in the mini-USB port [6] of

the camera.

8. While you press and hold the menu button on the camera, plug the

camera in a free USB port on your computer.

9. Release the menu button only when you hear a beep and the camera

display lights. The camera display shows “PC”.

Windows® automatically recognises the device and installs the driver.

Depending on the settings, Windows may (not) display the message

“Your new hardware is installed and ready for use”.

The camera is now ready for use as a webcam.

8. Troubleshooting

There is nothing on the display

Make sure the batteries are installed

correctly.

Replace empty batteries.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Pas de commentaire

Velleman CAMCOLVC18 Manuel d'utilisateur Page 11