Velleman VM122 Manuel d'utilisateur télécharger pdf (Page 6)

output & address selection

ADDRESS

SELECTION

D18 D19

1 Cut Cut

2 Cut Do not Cut

3 Do not cut Cut

OUTPUT SELECTION :

All outputs are toggle outputs by default.

To obtain a momentary output (pushbutton functionality), cut the

corresponding diode (D1...15).

For example: if you want to make output 5 a momentary instead of a

toggle output, cut or remove diode D5.

ADDRESS SELECTION :

Different possibilities in conjunction with diode setup:

The address selection allows you to operate up to 3 receivers in the same room without interference. Each receiver shall

have its own address setting.

 HINT: 3 receivers in the same room gives you 45 outputs thanks to address setting.

DEFAULT MODE : 3

 ATTENTION: the receivers can only be operated by a transmitter allowing address setting. For the setting of the

transmitter, we refer to the manual of VM121.

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Pas de commentaire

Velleman VM122 Manuel d'utilisateur Page 6