Velleman VM119 Manuel d'utilisateur télécharger pdf (Page 6)

1. Turn off the power.

2. Hold 'setup'-button.

3. Turn on power. LD1 and LD4 will start flashing

4. Release 'setup' when LD1 and LD4 stop flashing

 This process takes about 10 seconds.

 If the button is released before the leds stop flashing, the memory will not be cleared.

 The unit will now respond to the default code only.

TO REMOVE ALL STORED REMOTES FROM MEMORY AND TO RETURN TO FACTORY DEFAULTS

Configuration

1. Hold 'setup'-button. LD1 turns on.

2. Hold a remote button (1..8)

3. LD4 will light when the button has been stored

4. Release all buttons

Repeat steps 1 trough 4 to learn other remote buttons or remotes.

 31 transmitters or transmitter-buttons can be stored.

 If the memory is full, both LD1 and LD4 will flash rapidly.